Outlet Installation & Repair in Toronto

How Outlet Installation & Repair Works

1. 1

   Assessment

   We check the existing outlet, wiring, and circuit (or plan a new circuit run) to see what’s needed for your specific outlet or appliance.

2. 2

   Circuit & code review

   We confirm GFCI/AFCI requirements for the location and whether a dedicated circuit is needed for the load you’re adding.

3. 3

   Installation or repair

   We install the new outlet or dedicated circuit, or repair and replace the faulty outlet and connection, keeping the work clean and code-compliant.

4. 4

   Testing

   We test the outlet under load and confirm GFCI/AFCI protection is functioning correctly before we leave.

Frequently Asked Questions

My Riverdale house still has two-prong outlets — can I just get them replaced with grounded ones?

Not on their own if the circuit is knob-and-tube or otherwise ungrounded — swapping the outlet without fixing the circuit creates a false sense of grounding. We check what’s feeding the outlet first and either run a proper ground or install a GFCI-protected outlet labeled "no equipment ground," which is code-compliant.

I’m in a Yorkville condo and want a USB-C outlet added near my kitchen island — is that a big job?

Usually not. It’s typically a straightforward in-suite swap or a short run to the nearest junction box, though we’ll confirm your suite subpanel has room before adding anything on a dedicated circuit.

Do Leslieville and Beaches kitchen renos usually need more than one new outlet?

Often, yes. Older kitchens there were built with one or two shared outlets for the whole counter, so bringing them up to current code for appliance loads and GFCI protection usually means adding two or three dedicated circuits, not just relocating what’s there.

Can you add an outlet where there isn’t one?

Yes, we run new wiring and install outlets wherever you need them, including planning the circuit route through finished walls, basements, or exterior siding.

Do I need GFCI outlets, and where are they required?

GFCI protection is required by code in kitchens, bathrooms, garages, unfinished basements, and outdoor locations. We install GFCI outlets in these areas and can upgrade existing outlets that don’t have it.

Why is my outlet warm, sparking, or not working?

This usually points to a loose connection, a failing outlet, or an overloaded circuit rather than a one-off issue. We trace the fault to its actual source and repair or replace what’s causing it.

Do I need a dedicated circuit for a new appliance?

Larger appliances like freezers, microwaves, EV chargers, or workshop tools typically need their own dedicated circuit rather than sharing one with other outlets. We assess your specific appliance and panel capacity to confirm.

Do you install USB or USB-C outlets?

Yes, we install combo outlets with built-in USB and USB-C charging ports alongside standard receptacles, wherever you’d like them added.

How much does outlet installation or repair cost?

Cost depends on whether it’s a simple swap or a new circuit run, distance from your panel, and whether GFCI/AFCI protection or a dedicated circuit is needed. We provide a clear quote after assessing the job.