Sump Pump Panel Installation in Scarborough

How Sump Pump Panel Installation Works

1. 1

   Site & pump assessment

   We review your existing sump setup, or new pump specifications, pit depth, and alarm requirements to confirm the right panel sizing.

2. 2

   Panel selection & circuit planning

   We size the duplex control panel, breakers, and dedicated circuit to your pumps’ horsepower and voltage, and plan alarm wiring to a monitored point if required.

3. 3

   Installation & wiring

   We mount the panel and wire the pumps, float switches, alarm, and main disconnect, then configure lead/lag alternation and every Hand-Off-Auto setting.

4. 4

   Load testing & documentation

   We test both pumps under load, confirm alternation and alarm function, and provide ESA inspection documentation where the installation requires a permit.

Frequently Asked Questions

How do I know if my Scarborough home needs a panel upgrade?

Frequent breaker trips, flickering lights, or an original 60A or 100A panel are the most common signs. Many Scarborough homes built in the 1960s and 70s are due for an upgrade, especially ahead of a renovation or EV charger install.

What’s the difference between a simplex and duplex sump pump panel?

A simplex panel runs a single pump. A duplex panel controls two pumps, alternating which one leads on each cycle and automatically bringing in the second pump if the water level keeps rising, so one pump failure doesn’t mean a flooded sump.

Can the alarm be connected to a building monitoring system?

Yes, we can wire the high-water and pump-overload alarm outputs to a building management system, a monitored alarm panel, or a standalone audible/visual alarm, depending on what your property already has in place.

Do you install sump pump panels in parking garages and elevator pits?

Yes, duplex sump pump control panels are common in elevator pits, underground parking garages, and mechanical rooms, and we size and wire the panel to the specific pumps and pit conditions in each location.

Can you replace an existing single-pump setup with a duplex panel?

Yes, we regularly upgrade properties from a single float-switch pump to a proper duplex panel with alternation, alarms, and Hand-Off-Auto control, without needing to replace the pit itself in most cases.

Is a permit required for sump pump panel installation?

In most cases yes, particularly for panels tied to a dedicated circuit or building alarm system. We handle the ESA permit and inspection as part of the installation where one is required.

How much does a duplex sump pump panel cost?

Cost depends on the pumps’ horsepower and voltage, whether it’s simplex or duplex, and whether the alarm needs to integrate with a monitoring system. We provide a clear quote after reviewing your pit and pump specifications.