Security Alarm Installation in Richmond Hill

How Security Alarm Installation Works

1. 1

   Site walkthrough & sensor planning

   We review your property, identify entry points and areas to cover, and plan sensor and keypad placement against realistic wiring routes.

2. 2

   Power & panel planning

   We size the dedicated circuit and battery backup for your control panel, and confirm what wiring the sensor count and monitoring connection require.

3. 3

   Wiring installation

   We run new low-voltage wiring for door/window contacts, motion detectors, and sirens, or work with existing wiring where it’s in good condition.

4. 4

   Programming, testing & handover

   We install and program the panel and keypads, test every sensor and the monitoring connection, and confirm backup power holds before we leave.

Frequently Asked Questions

Do older Bayview Hill homes need full rewiring for an alarm system?

Usually yes, since homes from that era weren’t built with security wiring, so we run new low-voltage cable to each door and window zone rather than reusing anything existing.

My Oak Ridges lot is fairly large — does that change the alarm quote?

It can. Larger lots sometimes mean longer cable runs to a detached garage or shed, which adds a bit to the labour even though the wiring itself is straightforward.

Can you add a driveway or side-yard motion zone to a Mill Pond home’s system?

Yes, that’s a common add-on for larger properties there, wired as its own zone so it doesn’t trigger false alarms from the main house sensors.

Do you install the alarm system itself or just the wiring?

We handle the full installation, sensors, keypads, control panel, and the wiring and dedicated power behind them, plus programming and testing before handover.

Can you add sensors to an alarm system that already exists?

Yes, we regularly extend existing systems, adding door, window, or motion sensors to spare panel zones, or upgrading the panel if the existing one doesn’t have capacity for more.

Does the control panel need a dedicated circuit?

It should. A control panel sharing a circuit with other loads is more likely to lose power unexpectedly, which is why we size a dedicated circuit and properly rated battery backup for every installation.

What happens to my alarm system during a power outage?

A correctly sized battery backup keeps the control panel, sensors, and monitoring connection running through an outage. We size backup power to your system rather than relying on whatever came in the box.

Do you connect the system to a monitoring service?

Yes, we wire and set up the panel to connect with cellular or landline monitoring services so break-ins and power issues are reported around the clock.

How much does security alarm installation cost?

Cost depends on the number of sensors and zones, how much new wiring needs to be run, and whether a dedicated circuit is needed for the panel. We provide a clear quote after reviewing your property.