Exhaust Fan Installation in Richmond Hill

How Exhaust Fan Installation Works

1. 1

   Assessment & venting check

   We check your existing fan’s wiring and switch setup and, critically, where the duct actually terminates, since a disconnected or attic-vented duct is a common hidden issue.

2. 2

   Fan & circuit planning

   We size the fan in CFM to the room and help you choose between a standard, humidity-sensing, or fan/light/heater combo unit, then confirm whether a dedicated circuit or switch leg is needed.

3. 3

   Installation & duct routing

   We install the fan housing, run or correct the ductwork to a proper exterior vent cap, and wire it to its own switch or sensor control.

4. 4

   Testing

   We test airflow and confirm the duct is fully sealed and venting outside before we consider the job done, not just that the fan spins.

Frequently Asked Questions

Our Bayview Hill bathroom fan was added when we renovated years ago — how do we know if it’s actually vented outside?

We check by tracing the duct from the fan housing to its termination point. In homes of that era it’s common to find the duct simply ends in the attic rather than exiting through the roof or a wall, which we then correct.

We have a large primary ensuite in our Oak Ridges home — does the standard builder fan cover it?

Often not adequately. We size the fan’s airflow rating to the room’s actual square footage rather than assuming the builder-installed unit is sufficient, which is a common upgrade request in Oak Ridges’ larger newer homes.

Why does my bathroom still feel humid after running the exhaust fan?

This usually means the fan is underpowered for the room or, more often, that the duct isn’t actually venting outside. We check where your ductwork terminates as part of every assessment, since a disconnected or attic-vented duct is a surprisingly common issue.

Do I need a dedicated circuit for a new exhaust fan?

Not always. Many bathroom fans can run on a shared switch leg with the lighting, but a humidity-sensing or timer-controlled fan usually needs to operate independently, which we can wire as part of the installation.

Can you install an exhaust fan where there isn’t one currently?

Yes, including running new ductwork to a proper exterior vent cap and wiring a new switch or sensor control, for bathrooms or kitchens that were never fitted with one.

Is my home required to have a bathroom exhaust fan?

The Ontario Building Code requires mechanical ventilation in any bathroom without an operable window. Older homes sometimes predate this requirement or had a fan added without a permit, which we can assess and correct.

How much does exhaust fan installation cost?

Cost depends mainly on the ducting: whether an existing vent run can be reused, how far the fan is from an exterior wall or roofline, and whether a dedicated circuit is needed. We provide a clear quote after seeing the space.