High Bay Lighting Installation in Vaughan

How High Bay Lighting Installation Works

1. 1

   Site assessment & layout

   We measure ceiling height, existing fixture spacing, and layout obstacles like crane rails or racking, and plan fixture count and placement for even coverage.

2. 2

   Fixture & control selection

   We size LED high bay fixtures to your space and specify occupancy or daylight sensor controls where they’ll cut energy use without affecting visibility.

3. 3

   Removal & installation

   We safely remove old metal halide or fluorescent fixtures and install and wire the new LED fixtures and any new circuits from lift or scissor lift access.

4. 4

   Testing & walkthrough

   We test every fixture and control, confirm even coverage across the floor, and walk you through any sensor or dimming settings before we leave.

Frequently Asked Questions

Do custom homes in Woodbridge and Kleinburg need 200A panels?

Most do. Larger custom and estate homes with central air, pools, extensive lighting, and EV charging typically need 200A service as a baseline, and we size the panel to your home’s actual electrical load.

Do you design custom lighting for larger Vaughan properties?

Yes, we plan and install interior and exterior lighting layouts sized for larger floor plans and landscaped properties, including potlights, smart dimmers, and backyard and garden lighting.

How much can I save switching from metal halide to LED high bays?

LED high bay fixtures typically use 40-60% less energy than equivalent metal halide fixtures for the same light output, and last significantly longer, so the savings show up in both your power bill and reduced fixture replacement.

How high can your high bay fixtures be installed?

We install high bay fixtures from roughly 15 feet up to 40+ feet, sizing the fixture’s output and beam angle to the specific ceiling height so coverage stays even at floor level.

Do you remove and dispose of old fixtures?

Yes, we remove your existing metal halide or fluorescent high bay fixtures and handle disposal, including proper handling of any ballasts or lamps that require it.

Can high bay lighting be installed around a crane rail or racking?

Yes, we plan fixture placement around crane rails, ductwork, and racking layouts as part of the site assessment, so coverage stays even despite obstacles.

Do you install occupancy or daylight sensors with high bay lighting?

Yes, we install occupancy and daylight sensor controls where they make sense for the space, reducing energy use in areas that aren’t constantly occupied without affecting visibility when they are.

How much does high bay lighting installation cost?

Cost depends on fixture count, ceiling height, whether new circuits are needed, and whether old fixtures need removal. We provide a clear quote after assessing your space.