Generator Installation in Mississauga

How Generator Installation Works

1. 1

   Load assessment & sizing

   We calculate which circuits or appliances you want backed up and size the generator and transfer switch accordingly.

2. 2

   Placement & fuel planning

   We plan generator placement for code-required clearances and noise, and coordinate any gas line work with a licensed gas fitter if needed.

3. 3

   Installation

   We install the generator pad or mount, the automatic or manual transfer switch, and all wiring connecting it to your panel.

4. 4

   Permit, inspection & startup test

   We pull the ESA permit, schedule inspection, and run a startup test to confirm automatic switchover works correctly before we leave.

Frequently Asked Questions

Should Port Credit homeowners prioritize the sump pump on a generator’s critical circuits?

In most lakeside and older-lot homes with a finished basement, yes. We size the generator’s critical-circuit list around what would actually cause damage if it lost power, and a sump pump is usually at the top of that list for homes near the water.

Can a generator be sized around an existing EV charger and other loads in Erin Mills?

Yes, we do a full load assessment that accounts for your existing EV charger, HVAC, and other major circuits before recommending generator size, rather than sizing it in isolation.

Do I need an automatic transfer switch for a generator?

Yes, if you want the generator to switch on automatically during an outage, and it’s required by code for any generator connection to prevent backfeeding into utility lines regardless of switch type.

What size generator do I need for my home?

It depends on which circuits or appliances you want to keep running. We calculate the load for your must-have circuits, like a sump pump, furnace, and fridge, versus whole-home coverage, and size the generator accordingly.

Can I use a portable generator instead of a standby system?

Yes, with a properly installed interlock kit or transfer switch, a portable generator can safely power selected circuits during an outage at a lower cost than an automatic standby system.

Do you handle the gas line for a natural gas generator?

We coordinate the gas connection with a licensed gas fitter as part of the installation, while handling all the electrical work, wiring, and transfer switch ourselves.

Is a permit required for generator installation?

Yes, generator installations require an ESA permit and inspection, which we handle as part of every job.

How much does generator installation cost?

Cost depends on generator size, whether it’s whole-home or critical-circuit backup, transfer switch type, and any gas line work needed. We provide a clear quote after assessing your home.